Hoshizaki REFRIGERATED PREP TABLE WITH RAISED RAIL 73168 User Manual download pdf (Page 20)

f) Temperature Correction Factor

In cases where there is a discrepancy between the actual cabinet or rail temperature

and the displayed temperature, a temperature correction factor is used to correct the

displayed temperature.

WARNING

This unit has been factory tested with the default settings listed. Avoid using

this function except to conrm that the setting is correct. If set incorrectly, the

display could show an acceptable temperature even though the temperature

is out of the proper range. This value should only be changed after consulting

with the Hoshizaki Technical Support Department at 1-800-233-1940.

Toviewthecurrentvalues,movethepowerswitchtothe"ON"positionwhilepressing

the up arrow button. The current cabinet temperature correction factor will be shown. If

"18"isdisplayed,thevalueis1.8°F(1°C).Pressthecabinet"SET"buttontodisplaythe

rail temperature correction factor.

Temperature Correction Factor

Default

Area Setting Range 1-Section 2-Section 3-Section

Cabinet

-9 to 9

°F in 0.9°F increments

(-5 to 5°C in 0.5°C increments)

°F (0°C)

TBD

Rail

1. 8

°F (1°C) (0.9°F (0.5°C)

TBD

Negative values are indicated by an LED to the left of the value (Decimals are not

shown on display)

If it is determined through discussion with Hoshizaki Technical Support that the setting

needs to be changed, follow the steps below.

1) Display the cabinet or rail temperature correction factor as outlined above.

2) Press the up or down button to increase or decrease the cabinet value.

3)Pressthecabinet"SET"buttontosavethenewcabinetvalue.

4)Pressthecabinet"SET"buttonagaintoviewtherailvalue.

5) Press the up or down button to increase or decrease the rail value.

6)Pressthecabinet"SET"buttontosavethenewrailvalue.

7) Turn the power off and then back on. The unit will start running with the new value(s).

[Example]

When the actual cabinet temperature is 5.4°F (3°C) higher than the displayed temperature,

change the temperature correction factor to 5.4°F (3°C), so that the displayed temperature

matches the cabinet temperature.

Actual Area Temperature

Displayed Temperature

42.4

°F (6°C)

5.4

°F (3°C)

Difference

47.8°F (8.7°C)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 65 66

Comments to this Manuals

No comments

Hoshizaki REFRIGERATED PREP TABLE WITH RAISED RAIL 73168 User Manual Page 20

Comments to this Manuals