Hoshizaki REFRIGERATED PREP TABLE WITH RAISED RAIL 73168 User Manual Page 41

  • Download
  • Add to my manuals
  • Print
  • Page
    / 66
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 40
41
3)Allowthevacuumpumptopulldowntoa29.9"Hgvacuum.Evacuatingperioddepends
on pump capacity.
4) Close both gauge manifold valves.
5) Turn off the vacuum pump. Disconnect the vacuum pump hose and attach it to a
refrigerant service cylinder. Remember to loosen the connection, and purge the air
from the hose. See the nameplate for the required refrigerant charge. Hoshizaki
recommends only virgin refrigerant or reclaimed refrigerant which meets ARI Standard
No. 700 (latest edition) be used.
6) A liquid charge is recommended for charging an R-404A system. Invert the service
cylinder and place it on scales.
7) Open the high-side gauge manifold valve and allow the system to charge with liquid
until the proper charge is met.
8) If necessary, add any remaining charge to the system through the compressor access
valve. Use a throttling valve or liquid dispensing device to add the remaining liquid
charge through the compressor access valve with the unit running.
9) Back out the receiver service valve stem all the way and tighten. Disconnect the gauge
manifold hoses.
Note: Be sure the receiver service valve stem is backseated all the way out and tight
before disconnecting the gauge manifold hose.
10) Cap the valves to prevent possible leaks.
Fig. 1
Rail Refrigerant Tubes
Rail Low-Side Service Valve
Rail High-Side Service Valve
Hex Head Bolt
Cabinet Liquid Line Valve
Cabinet Expansion Valve
Rail Expansion Valve
Rail High-Side
Access Valve
Rail Low-Side
Access Valve
Compressor
Access Valve
Rail Service Valve Bracket
Power Switch
Receiver Service Valve
Rail Cooling Switch
Wire Cover
Upper Attachment Nut
and Washer
Lower Attachment Nut
and Washer
Power Cord
Rail Liquid Line Valve
Compressor
Receiver Tank
Condenser
Drier
Page view 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 65 66

Comments to this Manuals

No comments