Hoshizaki REFRIGERATED PREP TABLE WITH RAISED RAIL 73168 User Manual download pdf (Page 57)

K. Removal and Replacement of Door Gasket

Remove the old gasket by pulling it directly out of the vinyl gasket retainer. Thoroughly

clean the gasket area with mild soap and water prior to installing the new gasket. The

new gasket should be installed at the corners rst, then working toward the center at

the top, bottom, and sides. The arrow-shaped portion of the gasket should be rmly

seated in the retainer groove for proper assembly. This can be checked by lifting the

edge of the gasket and observing the engagement.

CAUTION

In order to get a proper gasket t, it is important not to stretch gasket material

during assembly.

L. Door Re-Hinging and Drawer Conversion

Contact your local Hoshizaki distributor or Hoshizaki Technical Support if door reversing

or drawer conversion is desired.

7) Remove the rail access hole sealant and grommet.

8) Push the old fan motor wires (with new fan motor wires securely attached) into the rail

channel. Once the new fan motor wires are in the channel, replace the access hole

grommet. Remove the left side panel, then pull the fan motor wires through the rail

channel.

9) Disconnect and discard the old fan motor wires. Connect the new fan motor wires.

10) Seal the rail access hole with food grade silicone.

11) Place the new rail fan motor and the fan motor shroud in their correct positions and

secure. Make sure all wires are clear of the fan.

12) Replace the panel and empty storage pans in their correct positions.

13)Plugintheunit,thenmovethepowerswitchtothe"ON"positionandtherailswitchto

the"NORMAL"positiontostarttheunit'scoolingprocess.

14) Do not place food products in the rail area until the rail section has cooled down.

Rail Fan Motor

Rail Fan Motor Shroud

Fig. 11

Rail Fan Motor Bracket

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 65 66

No comments

Hoshizaki REFRIGERATED PREP TABLE WITH RAISED RAIL 73168 User Manual Page 57