Hoshizaki KM-501MRH User Manual download pdf (Page 10)

II. Installation and Operating Instructions

A. Checks Before Installation

IMPORTANT

1. Remove shipping carton, tape(s) and packing. If packing material is left

in the icemaker, it will not work properly.

2. Ensure all components, fasteners and thumbscrews are securely in place.

1) Remove the panels to prevent damage when installing the icemaker. See "B. How to

Remove Panels."

2) Remove the package containing the accessories.

3) Remove the protective plastic ﬁlm from the panels. If the icemaker is exposed to the

sun or to heat, remove the ﬁlm after the icemaker cools.

4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that

the fan blade turns freely.

5) Check that the compressor is snug on all mounting pads.

6) See the nameplate on the rear panel, and check that your voltage supplied

corresponds with the voltage speciﬁed on the nameplate.

7) This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI

ICE STORAGE BIN, Model B-300 series.

8) On remote air-cooled models, a remote condenser unit is needed. The

recommended remote condenser unit is HOSHIZAKI CONDENSER UNIT, MODEL

URC-6F.

B. How to Remove Panels

See Fig. 1

• Front Panel: Remove the screw. Lift up and pull

towards you.

• Top Panel: Lift up slightly its front, push away, and

then lift off.

• Side Panel (R): Remove the screw. Pull slightly

towards you, and lift off.

• Insulation Panel: Lift up slightly, and pull towards

you.

• Base Cover: Lift up slightly, and pull towards you.

Fig. 1

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

No comments

Hoshizaki KM-501MRH User Manual Page 10