Hoshizaki KM-501MRH User Manual download pdf (Page 20)

I. Startup

CAUTION

1. All parts are factory-adjusted. Improper adjustments may result in failure.

2. If the unit is turned off, wait for at least 3 minutes before restarting the

icemaker to prevent damage to the compressor.

3. Do not operate the unit in the "WASH" position without water in the water

tank. This will cause damage to the water pump seal.

1) Open the water supply line shut-off valve.

2) Remove the front panel.

3) Move the control switch on the control box to the "ICE" position.

4) Replace the front panel in its correct position.

5) Turn on the power supply, and allow the water tank to ﬁll with water and the icemaker to

operate for a total of 10 minutes.

6) Turn off the power supply, and remove the front panel and the base cover.

7) Remove one end of the pump tubing, and drain the water tank. See Fig. 10.

8) Replace the pump tubing in its correct position.

9) Clean the storage bin.

10) Replace the base cover and the front panel in their correct positions.

11) Turn on the power supply, and start the automatic icemaking process.

Fig. 10

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

No comments

Hoshizaki KM-501MRH User Manual Page 20