Hoshizaki KM-2000SRH3 User Manual download pdf (Page 8)

II. INSTALLATION AND OPERATING INSTRUCTIONSII. INSTALLATION AND OPERATING INSTRUCTIONS

II. INSTALLATION AND OPERATING INSTRUCTIONS

1. CHECKS BEFORE INSTALLATION1. CHECKS BEFORE INSTALLATION

1. CHECKS BEFORE INSTALLATION

IMPORTANTIMPORTANT

IMPORTANT

1. Remove shipping carton, tape(s) and packing. If packing material is left in

the icemaker, it will not work properly.

2. Ensure all components, fasteners and thumbscrews are securely in place.

1) Remove the panels to prevent damage when installing the icemaker. (See “2. HOW TO

REMOVE PANELS.”)

2) Remove the package containing the accessories from the compressor compartment.

3) Remove the protective plastic film from the panels. If the icemaker is exposed to the sun

or to heat, remove the film after the icemaker cools.

4) Check that the refrigerant lines do not rub or touch lines or other surfaces.

5) Check that the Compressor is snug on all mounting pads.

6) See the Nameplate on the Rear Panel, and check that your voltage supplied corresponds

with the voltage specified on the Nameplate.

7) This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE

STORAGE BIN, Model B-800 series.

8) On remote air-cooled models, a remote condenser unit is needed. The recommended

remote condenser unit is HOSHIZAKI CONDENSER UNIT, Model URC-20F.

2. HOW TO REMOVE PANELS - See Fig. 12. HOW TO REMOVE PANELS - See Fig. 1

2. HOW TO REMOVE PANELS - See Fig. 1

a) Front Panel ......... Remove the two screws.

Lift up and pull toward you.

b) Top Panel............ Remove the two screws,

and then lift off.

c) Side Panel (R)..... Remove the screw.

Pull slightly toward you,

and take off.

d) Insulation Panel .. Remove the Thumbscrew.

Lift up slightly, and pull toward

you.

Fig. 1Fig. 1

Fig. 1

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 28 29

No comments

Hoshizaki KM-2000SRH3 User Manual Page 8