Hoshizaki KM-2000SRH3 User Manual download pdf (Page 22)

10. START UP10. START UP

10. START UP

CAUTIONCAUTION

CAUTION

1. All parts are factory-adjusted. Improper adjustments may result in failure.

2. If the unit is turned off, wait for at least 3 minutes before restarting the

icemaker to prevent damage to the Compressor.

3. Do not operate the unit in the “WASH” position without water in the Water

Tank. This will cause damage to the Water Pump seal.

1) Open the Water Supply Line Shut-off Valve.

2) Remove the Front Panel.

3) Move the Control Switch, on the Control Box, to the “ICE” position.

4) Replace the Front Panel in its correct position.

5) Turn on the power supply, and allow the Water Tank to fill with water and the icemaker

to operate for a total of 10 minutes.

Note: If miswiring causes excessive voltage on the Controller Board, the High Voltage

Cut-out shuts down the circuit in 3 seconds and the icemaker automatically stops.

When the proper supply voltage is resumed, the icemaker automatically starts

running again.

6) Turn off the power supply, and remove

the Front Panel.

7) Remove the Insulation Panel. Remove

the Cap located on the front bottom part

of the Ice Dropping Hole. Drain the

Water Tank. See Fig. 13.

8) Replace the Cap, Insulation Panel and

Front Panel in their correct positions.

9) Clean the Storage Bin.

10) Turn on the power supply, and start the

automatic icemaking process.

Fig. 13Fig. 13

Fig. 13

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29

No comments

Hoshizaki KM-2000SRH3 User Manual Page 22