Hoshizaki F-330BAH(-C) User Manual download pdf (Page 14)

4) Remove the top panel.

5) Remove the bin control assembly from the top insulation and set it aside. Remove the

top insulation.

6) Remove the thumbscrews attaching spout (B) to the bin, then remove spout (B).

7) Remove the thumbscrews attaching spout (A) and safety bracket (A) to the evaporator

assembly, then remove spout (A) and safety bracket (A).

8) Pour the sanitizing solution over the extruding head until the evaporator assembly and

the reservoir are lled and the solution starts to overow into the drain pan.

9) Allow the icemaker to sit for about 10 minutes before operation.

10) Replace all parts in their correct positions. Make sure safety bracket (A) is in position as

illustrated in Fig. 7.

11) Plug the unit back in. Move the ush switch

to the "ICE" position and move the power

switch to the "ON" position. Replace the

panels in their correct positions and allow

the unit to make ice using the solution until

it stops automatically.

1) Remove the front panel.

13) Move the ush switch to the "FLUSH"

position to drain the remainder of the

solution.

14) After the solution has drained, move the

ush switch to the "ICE" position.

15) Replace the front panel in its correct position.

16) Open the water supply line shut-off valve to supply water to the reservoir.

17) When the gear motor starts, remove the front panel and move the ush switch to the

"FLUSH" position to drain out the water from the icemaker.

18) After the water has drained, move the ush switch to the "ICE" position and allow the

icemaker to run. Replace the front panel in its correct position.

19) After 30 minutes, remove the front panel and move the power switch to the "OFF"

position. Unplug the unit.

0) Pour warm water into the storage bin to melt all ice, then clean the bin liner with the

solution.

1) Flush out any solution from the storage bin.

) Plug the unit back in. Move the power switch to the "ON" position to start the automatic

icemaking process.

3) Replace the front panel in its correct position.

Safety Bracket (A)

Safety Bracket (B)

Safety Switch

Spout

Fig. 7

1 2 ... 9 10 11 12 13 14 15 16 17

No comments

Hoshizaki F-330BAH(-C) User Manual Page 14