Hoshizaki KM-101BAH User Manual download pdf (Page 9)

II. Installation and Operating Instructions

A. Checks Before Installation

* Visually inspect the exterior of the shipping container, and any severe damage noted

should be reported to the carrier.

IMPORTANT

1. Remove shipping carton, tape(s) and packing. If packing material is left in

the icemaker, it will not work properly.

2. Ensure all components, fasteners and thumbscrews are securely in place.

3. Remove the shipping tapes holding the Door and Separator. See Fig. 1.

1) Remove the panels to prevent damage when installing the icemaker. (See “B. How to

Remove Panels”.)

2) Remove the package containing accessories.

3) Remove the protective plastic ﬁlm from the panels. If the icemaker is exposed to the

sun or to heat, remove the ﬁlm after the icemaker cools.

4) Check that refrigerant lines do not rub or touch lines or other surfaces, and that the fan

blade turns freely.

5) Check that the Compressor is snug on all mounting pads.

6) See the Nameplate on the upper part of the Left Side Panel, and check that your voltage

supplied corresponds with the voltage speciﬁed on the Nameplate.

B. How to Remove Panels

- See Fig. 1

* Louver: Remove the Air Filter. Lift it up and towards you.

Push down snap tabs at the top on both sides by a ﬂat head screwdriver,

pull towards you slightly, and lift off.

* Top Panel: Remove the screws. Slide rearward, and lift off.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

No comments

Hoshizaki KM-101BAH User Manual Page 9