Hoshizaki KM-101BAH User Manual download pdf (Page 11)

* The icemaker requires no clearance at either side. But allow enough space at rear for

water supply and drain connections, at least 12” (approx. 30 cm) clearance at front, and

at least 0.6” (approx. 15 mm) clearance at top for maintenance.

D. Electrical Connection

WARNING

THIS APPLIANCE MUST BE GROUNDED.

This icemaker requires a ground that meets the national and local electrical

code requirements. To prevent possible severe electrical shock injury to

individuals or extensive damage to equipment, install a proper ground wire

to this icemaker. Remove the plug from the electrical outlet before any

maintenance, repairs or cleaning is undertaken.

CAUTION

The GREEN ground wire in the factory-installed power cord is connected to

a screw on the bracket where the cord enters the machine. If it becomes

necessary to remove or replace the power cord, be sure to connect the power

cord’s ground wire to this screw upon reattachment.

* This icemaker must be plugged into an independent power receptacle which has enough

capacity. The maximum allowable voltage variation should not exceed ± 10 percent of the

nameplate rating. See the Nameplate.

* Usually an electrical permit and services of a licensed electrician are required.

E. Set Up

IMPORTANT

Do not place heavy objects exceeding 33 lbs (15 kg) on the Top Panel.

1) Unpack the icemaker, and remove all shipping cartons, tapes and packing BEFORE

operating the unit.

2) Position the icemaker in a selected site. Clean the interior with soap and water and

rinse thoroughly.

3) Level the icemaker in both the left-to-right and the front-to-rear directions (when installed

with or without legs). See Fig. 2.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

No comments

Hoshizaki KM-101BAH User Manual Page 11