Hoshizaki KM-2500SRH3 User Manual download pdf (Page 60)

B. Maintenance

IMPORTANT

This icemaker must be maintained individually, referring to the instruction

manual and labels provided with the icemaker.

1. Stainless Steel Exterior

To prevent corrosion, wipe the exterior occasionally with a clean, soft cloth. Use a damp

cloth containing a neutral cleaner to wipe off oil or dirt build up.

2. Storage Bin and Scoop

• Wash your hands before removing ice. Use the plastic scoop provided (bin accessory).

• The storage bin is for ice use only. Do not store anything else in the storage bin.

• Clean the scoop and the storage bin liner using a neutral cleaner. Rinse thoroughly

after cleaning.

3. Condenser (remote air-cooled model only)

Check the condenser once a year, and clean the coil if required by using a brush or

vacuum cleaner. More frequent cleaning may be required depending on location.

C. Preparing the Icemaker for Long Storage

CAUTION

1. When storing the icemaker for an extended time or in sub-freezing

temperatures, follow the instructions below to prevent damage.

2. To prevent damage to the water pump seal, do not operate the icemaker with

the control switch in the "WASH" position when the water tank is empty.

When the icemaker is not used for two or three days, it is sufficient to only move the control

switch to the "OFF" position, unless the icemaker will be at sub-freezing temperatures.

1. Remove the water from the icemaker water supply line:

1) Turn off the power supply, then remove the front panel.

2) Close the icemaker water supply line shut-off valve and open the icemaker water supply

line drain valve.

3) Allow the line to drain by gravity.

4) Attach a compressed air or carbon dioxide supply to the icemaker water supply line

drain valve.

5) Make sure at least 3 minutes have elapsed since you turned off the power supply. Make

sure the control switch is in the "ICE" position. Replace the front panel in its correct

position and turn on the power supply.

6) Blow the icemaker water supply line out using the compressed air or carbon dioxide

supply.

7) Close the icemaker water supply line drain valve.

1 2 ... 55 56 57 58 59 60 61

No comments

Hoshizaki KM-2500SRH3 User Manual Page 60