Hoshizaki Low-Profile Modular Crescent Cuber MRH User Manual download pdf (Page 19)

1. Icemaker

Icemaker Water

Supply Inlet

Minimum Icemaker

Water Supply Line Size

Icemaker Drain

Outlet

Minimum Icemaker

Drain Line Size

1/2" Female Pipe

Thread (FPT)

1/4" Nominal ID

Copper Water Tubing or

Equivalent

3/4" Female Pipe

Thread (FPT)

3/4" Nominal

ID Hard Pipe or

Equivalent

• An icemaker water supply line shut-off valve and drain valve must be installed.

• Be sure there is sufficient extra water supply line and drain line for the appliance to be

pulled out for service.

Fig. 4

Model Shown:

KML-631MRH

Air-Cooled and Remote Models

Remote Condenser

Line Set Connections

(Remote Model)

Shut-Off Valve

Drain Valve

Icemaker

Icemaker Water

Supply Inlet

1/2" FPT

Bin Drain Outlet

3/4" FPT

2-inch (5-cm) air gap

Floor

Drain

Icemaker

Drain Outlet

3/4" FPT

Minimum 1/4" Nominal ID Copper

Water Tubing or Equivalent

Vent Tube

Minimum 3/4" Nominal ID

Hard Pipe or Equivalent

Ice

Storage

Bin

Separate piping to approved

drain. Leave a 2-inch (5-cm)

vertical air gap between the

end of each pipe and the

drain.

Be sure there is sufficient

extra water supply line and

drain line for the appliance

to be pulled out for service.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Comments to this Manuals

No comments

Hoshizaki Low-Profile Modular Crescent Cuber MRH User Manual Page 19

Comments to this Manuals

Related products and manuals for Ice cube makers Hoshizaki Low-Profile Modular Crescent Cuber MRH