Hoshizaki KM-255BAH User Manual

Hoshizaki“A Superior Degreeof Reliability”www.hoshizaki.comModelsKM-255BAHKM-255BWHSelf-Contained Crescent CuberHoshizaki America, Inc.Issued: 10-4-20

10E. Water Supply and Drain ConnectionsSee Fig. 2CAUTIONTo prevent damage to equipment, do not operate this icemaker when the water supply is OFF, or

11KM-255BAHKM-255BWHSeparate piping to approved drain. Leave a two-inch (5 cm) vertical air gap between the end of each pipe and the drain.Fig. 2Icema

12F. Final Checklist1) Is the icemaker level?2) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (+7°C to +38°C) and

13G. StartupCAUTION1. All parts are factory-adjusted. Improper adjustments may result in failure.2. If the unit is turned off, wait for at least 3 min

14III. Cleaning and Maintenance InstructionsIMPORTANTEnsure all components, fasteners and thumbscrews are securely in place after any maintenance or c

1519) Remove the float switch from the water tank by pulling out on the right-side wall of the water tank slightly and sliding the float switch upward.

162. Sanitizing Procedure - Following Cleaning Procedure1) Dilute approximately 0.5 fl. oz. (15 ml or 1 tbs) of a 5.25% sodium hypochlorite solution (c

173. Air Filter (air-cooled model only)The plastic mesh air filter removes dirt and dust from the air, and keeps the condenser from getting clogged. As

1813) Move the control switch to the OFF position.14) Reconnect the suction hose and harvest water valve hose.15) Close the potable water supply line

19HOSHIZAKI AMERICA, INC.618 Hwy. 74 S., Peachtree City, GA 30269 USA TEL (770) 487-2331 FAX (770) 487-3360 www.hoshizaki.com 91A1AT10A

2IMPORTANTOnly qualified service technicians should attempt to install, service or maintain this icemaker. No installation, service or maintenance shou

3• Please review this manual. It should be read carefully before the icemaker is installed and operated. Only qualified service technicians should inst

4I. SpecificationsA. Nameplate Rating1. KM-255BAH (air-cooled)See the nameplate for electrical and refrigeration specifications. This nameplate is locat

52. KM-255BWH (water-cooled)See the nameplate for electrical and refrigeration specifications. This nameplate is located on the upper left hand side of

6B. Dimensions/Connections1. KM-255BAHUnit: mm. [inches]

72. KM-255BWHUnit: mm. [inches]Intentionally Left Blank

8II. Installation And Operating InstructionsA. Checks Before InstallationIMPORTANT1. Remove shipping carton, tape(s) and packing. If packing material

9C. LocationWARNINGThis icemaker is not intended for outdoor use. Normal operating ambient temperature should be within +45°F to +100°F (+7°C to +38°C