Hoshizaki KM-1301SAH/3 User Manual download pdf (Page 81)

1. Cleaning Procedure

1) Dilute 7 . oz. (800 ml) of recommended cleaner Hoshizaki "Scale Away" or

"LIME-A-WAY" (Economics Laboratory, Inc.) with 5 gal. (19 l) of warm water.

) Remove all ice from the evaporator and the storage bin.

Note: To remove cubes on the evaporator, turn off the power supply and turn it on

after 3 minutes. The harvest cycle starts and the cubes will be removed from the

evaporator.

3) Turn off the power supply.

4) Remove the front panel, and then remove

the insulation panel by rst removing the

thumbscrew, lifting up the panel slightly

and pulling it towards you.

5) Remove the cap located on the front

bottom part of the ice dropping hole. Drain

the water tank. See Fig. 5.

6) Replace the cap in its correct position. Be

careful not to cross thread it.

7) In bad or severe water conditions, clean the oat switch assembly as described below.

Otherwise, continue to step 8.

a. Disconnect the vent tube and the ush tube from the top of the oat switch, then

remove the oat switch assembly from the mounting bracket and remove the

rubber boot from the bottom of the assembly.

b. Remove the retainer rod from the bottom of the oat switch assembly, then remove

the oat. Be careful not to bend the retainer rod excessively when removing it.

c. Wipe down the oat switch assembly's housing, shaft, oat, and retainer rod with

cleaning solution. Clean the inside of the rubber boot and hose with cleaning

solution. Rinse the parts thoroughly with clean water.

d. Reassemble the oat switch assembly and replace it and the rubber boot in their

correct positions. Reconnect the vent tube and the ush tube.

8) Pour the cleaning solution into the water tank.

9) Fully open the cleaning valve on the left side wall of the machine compartment.

10) Move the control switch on the control box to the "WASH" position.

11) Replace the insulation panel and the front panel in their correct positions.

1) Turn on the power supply to start the washing process.

13) Turn off the power supply after 30 minutes.

14) Remove the front panel and the insulation panel.

15) Remove the cap located on the front bottom part of the ice dropping hole. Drain the

water tank. Replace the cap and the insulation panel in their correct positions.

16) Move the control switch to the "ICE" position.

17) Close the cleaning valve.

Note: The icemaker will not operate unless the cleaning valve is completely closed.

Fig. 5

Front

Inside of Ice

Dropping Hole

Cube Guide

Separator

Cap

1 2 ... 76 77 78 79 80 81 82 83 84

Comments to this Manuals

No comments

Hoshizaki KM-1301SAH/3 User Manual Page 81

Comments to this Manuals

Related products and manuals for Ice cube makers Hoshizaki KM-1301SAH/3