Hoshizaki “A Superior Degree of Reliability” www.hoshizaki.com ModelsKM-1400SWH/3-MModular Crescent Cuber Hoshizaki America, Inc. Issued: 5-26-2010IN
105) Install the bin control thermostat as follows: a. Remove the baffle from the bin.b. Remove the tie securing the bin control thermostat assembly.
11E. Installation of Second Unit1) See "II.D. Setup" for the lower unit installation.2) Remove the top panel and the top insulation of the l
127) Remove the tie securing the upper unit's bin control thermostat assembly.8) Remove the bin control thermostat assembly from the shipping hoo
13F. Electrical Connection WARNING1. Electrical connection must be hard-wired and must meet international, national, state, and local electrical code
14G. Water Supply and Drain ConnectionsSee Fig. 9 or 10 WARNING1. Water supply and drain connections must be installed in accordance with applicable i
152. Water-Cooled Condensera) Connection to an Open Drain System• Condenser water supply inlet is 1/2" female pipe thread (FPT). A minimum of 3/8
16b) Connection to a Closed Loop System• Condenser water supply inlet is 1/2" female pipe thread (FPT). A minimum of 3/8" nominal copper wat
17H. Final Checklist WARNINGCHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after installation. Make sure that
18I. Startup WARNING1. All parts are factory-adjusted. Improper adjustments may adversely affect safety, performance, component life, and warranty cov
19CLOSEDNormal Icemaking OperationOPENCleaning and Sanitizing Operation(allows solution ow to the inside of the evaporator)III. Cleaning and Maintena
2IMPORTANTOnly qualied service technicians should install, service, and maintain the icemaker. No installation, service, or maintenance should be und
201. Cleaning Procedure1) Dilute 27 . oz. (800 ml) of Hoshizaki "Scale Away" with 5 gal. (19 l) of warm water.2) Remove all ice from the ev
2122) Move the control switch to the "WASH" position.23) Replace the front panel in its correct position.24) Turn on the power supply to rin
22B. MaintenanceThis icemaker must be maintained individually, referring to the instruction manual and labels provided with the icemaker. WARNING1. On
232. Drain the water tank:1) Turn off the power supply, then remove the front panel. Move the control switch to the "OFF" position.2) Remove
24HOSHIZAKI AMERICA, INC. 618 Hwy. 74 S., Peachtree City, GA 30269 USA TEL (770) 487-2331 FAX (770) 487-3360 www.hoshizaki.com 91A7DH10A
3CONTENTSImportant Safety Information ... 4I. Specicati
4Important Safety InformationThroughout this manual, notices appear to bring your attention to situations which could result in death, serious injury,
5MOTOR-COMPRESSOR THERMALLY PROTECTED, NOT INTENDED FOR OUTDOOR USE!Hoshizaki America, Inc.Peachtree City, GAwww.hoshizaki.comICE MAKER WITHOUT STORAG
6MOTOR-COMPRESSOR THERMALLY PROTECTED, NOT INTENDED FOR OUTDOOR USE!Hoshizaki America, Inc.Peachtree City, GAwww.hoshizaki.comICE MAKER WITHOUT STORAG
7B. Dimensions/Connections1. KM-1400SWH/3-M (water-cooled marine)Unit: (mm) in.Note: When used with a storage bin not recommended by Hoshizaki, the ic
8II. Installation and Operating Instructions WARNING1. This icemaker must be installed in accordance with applicable international, national, state, a
9C. LocationCAUTION1. This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within 45°F to 100°F (7°C to 38°C)
Comments to this Manuals