Hoshizaki KM-1300NRF User Manual

1ISSUED:KM-1300NRFMODELINSTRUCTION MANUALHOSHIZAKIMODULAR CRESCENT CUBERJUNE 1, 2000REVISED:JUNE 7, 2000

106. INSTALLATION OF REMOTE CONDENSER UNIT[a] CHECKS BEFORE INSTALLATION1) Unpack and remove shipping carton, tape(s) and packing.2) Check that the re

11[c] SET UP1) Secure the Legs to the condenser unit with eight M8 x 16 mm Hexagon Bolts and M8 Nutsas shown in the illustration. See Fig. 6.Note: Lo

12Fig. 8[d] ELECTRICAL CONNECTIONWARNINGThis remote condenser unit requires a ground that meets the national andlocal electrical code requirements. T

13[e] STACKING CONDENSER UNIT1) Secure the lower condenser unit to the Legs with eight bolts (not included).2) Attach the upper condenser unit on the

147. WATER SUPPLY AND DRAIN CONNECTIONS - See Fig. 10WARNINGTo prevent damage to the pump assembly, do not operate the icemaker whenthe water supply i

15Fig. 10

168. FINAL CHECK LIST1) Is the icemaker level?2) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F all yeararound?3) I

179. START UPWARNING1. All parts are factory-adjusted. Improper adjustments may result in failure.2. If the unit is turned off, wait for at least 3 m

1810 . PREPARING THE ICEMAKER FOR LONG STORAGEWARNINGWhen shutting off the icemaker for an extended time, drain out all water fromthe water tank and r

19III. MAINTENANCE AND CLEANING INSTRUCTIONS1. CLEANING INSTRUCTIONSWARNING1. HOSHIZAKI recommends cleaning this unit at least once a year. Morefrequ

2HOSHIZAKI AMERICA, INC.618 Highway 74 SouthPeachtree City, GA 30269Attn: HOSHIZAKI Technical Support DepartmentPhone: 1-800-233-1940 Technical Ser

20Note: To remove cubes on the Evaporator, turn off the power supply and turn it on after3 minutes. The defrost cycle starts and the cubes will be re

2124) Turn off the power supply after 5 minutes.25) Remove the Front Panel and the Insulation Panel.26) Remove the Cap located on the front bottom par

222. MAINTENANCEIMPORTANTThis icemaker must be maintained individually, referring to the instructionmanual and labels provided with the icemaker.1) St

2391A1DL10AHOSHIZAKIHOSHIZAKI AMERICA, INC.618 HIGHWAY 74 SOUTHPEACHTREE CITY, GA 30269U.S.A.PHONE: 770-487-2331

3  Please review this manual. It should be read carefully before the icemaker is installed andoperated. Only qualified service technicians should

4I. SPECIFICATIONS1. NAMEPLATE RATINGSee the Nameplate for electrical and refrigerationspecifications. This Nameplate is located on theupper right ha

52. DIMENSIONS/CONNECTIONSNote: When used with a storage bin not recommended by Hoshizaki, the icemaker needsthe space at the bottom opening as in the

6II. INSTALLATION AND OPERATING INSTRUCTIONS1. CHECKS BEFORE INSTALLATIONIMPORTANTRemove shipping carton, tape(s) and packing. If packing material is

73. LOCATIONWARNINGThis icemaker is not intended for outdoor use. Normal operating ambienttemperature should be within +45°F to +100°F; Normal opera

8Fig. 3Fig. 2

95. ELECTRICAL CONNECTIONWARNING1. Electrical connection must be made in accordance with the instructions onthe “WARNING” tag, provided with the pig t